NOKIA 222 DUAL SIM CHARGING WAY SOLUTION
Hi guys today i am going to tech or give you tutorials about how to solve Nokia 222 charging way damage.
But before we move into our tutorial we have to know why and how Nokia 222 charging mostly have charging way problems.
WHY NOKIA 222 CHARGING WAY DAMAGE?
in some cases water may be the cause of damaging charging way or any liquid substance like milk,slaver.etc
Secondly plugging unsupported charger may cause permanent damage or may cause
your mobile phone dead. this is the most dangerous action.
HOW TO AVOID PROBLEMS?
The way of avoiding having charging way damage mottle know as charging point way. is that:
1. Avoid holding your mobile phone with mouth because slaver may intact the phone without your knowing.
2. Avoid trying any charger when charging, make sure you use the original charger that the phone come with or any charger that equal to the voltage that your phone require. "the voltage that your mobile require is writes in your mobile hand manual".
3.Make sure you check the charging pins before connecting the charger to your phone charging hub.
WHEN I HAVE CHARGING PROBLEMS HOW WILL I SOLVE IT WITHOUT TAKING IT TO ENGINEERS?
ofcouse you can try some basic first aid to your mobile phone before taking it to engineers, here are the most basic first aid you have to perform:
step 1. remove the battery from the phone use toothbrush "because i know its easily to get it in anyway" apply petrol or thinner,spirit if any gentle clean the battery head and the battery terminals or battery socket, wait 2 mins to 3 min until the battery and the terminals dry, insert your battery and plug charging.
step 2. if step 1 is not solve your problems then clean the charging way (charging point or charging connector) with thinner,petrol,spirit wait till it dry, and then try again.
step 3. if step 1,2 did not solve your problems, the try another charger may be your charger spoil, and try again.
step 4. I try step 1,2,3 but nothing change!! The final steps is to take it to engineers.
Note: I am not advising you to uncouple your mobile phone if you are not engineer or using own experience is on your own risk.
I AM ENGINEER I TRIED REPLACING CHARGING POINT (connector) BUT IT DID NOT WORKING
now as you are engineer i believe you do not need much more explanation about how to take charging way jumper, now take a look in the below picture just remove that mini glass ic which normally known as charging ic then take a jumper from pin-out area then go ahead with your tutor on the picture.
Glass Ic or Charging Ic
I wish you good-luck
if this helps you do not forget to leave your comment and share thanks
0 Comments